Three pin molex connector kk family this molex connector is used when connecting a fan to the motherboard or other circuit board.
Computer 3 pin fan connector pinout.
3 pin connectors are usually used for the smaller chassis fans with lower power consumption.
Typically the motherboard is required to pull the pin up through a resistor with the fan connecting it to ground once or more per revolution.
Ground 12 v sense control.
The signal wire measures how fast the fan is moving without any controls for the fan s speed.
A three pin connector is basically power 5 12 volt ground and signal.
A pwm capable fan is usually connected to a 4 pin connector pinout.
Fans and on board fan headers are backwards compatible.
Note that chassis and cpu fans may use either 3 pin or 4 pin power connectors.
2 pack sata to 3 pin 4 pin pmw 12v pc case fan power adapter cable 3 pin or 4 pin pwm connector to 15 pin sata computer cooler cooling fan power cable 4 0 out of 5 stars 24 7 59 7.
On space constricted fan control hubs the 4 pin connector failed to lock onto the fan s wire leading to the adapter falling off the fan s wire lead.
With this type fan speed is typically controlled by increasing or decreasing the voltage over the power wire.
So these adapters arrived and were much needed.
Connectors usually used for computer fans are the following.
The 3 pin senses fan rpm revolutions per minute.
A 3 pin fan connector will be smaller in size than the 4 pin pwm fan connector.
Fans with three pin connectors must be used on 3 pin cpu fan pinouts.
But after attempting to use them they worked out pitifully.
3 pin connectors are usually used for the smaller chassis fans with lower power consumption.
The image below displaying is the difference between a 4 pin pwm fan connector left and a 3 pin fan connector right.
The sense pin is used to relay the rotation speed of the fan and the control pin is an open drain or open collector output which requires a pull up to 5 v or 3 3 v in the fan.
3 pin connectors are usually used for the smaller chassis fans with lower power consumption while 4 pin connectors are usually used by cpu fans with higher power consumption.
Chassis and cpu fans may use either 3 pin or 4 pin power connectors.
When no revolutions are sensed by the system an audio alarm or no system boot will occur warning the user or preventing proccessor overheating and burnout.
While they look nice and do adapt 4 pin fans to 3 pin outlets esp.
4 pin connectors are usually used by cpu fans with higher power consumption.
4 pin connectors are usually used by cpu fans with higher power consumption.